Epson Stylus Pro 10000 - C362 MAIN Board Removal

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 135
4.3.2.3 C362MAIN Board Removal
1. Remove the Rear Cover as described in 4.3.1.7 "Rear Cover Removal".
2. Remove eight screws securing the I/F bracket, then remove the I/F bracket and two
earth plate.
Figure 4-47.
3. Remove six screws securing the C362MAIN Board.
Figure 4-48.
4. Slide the C362MAIN Board 20 to 30mm to the left, then remove the C362MAIN
Board.
Figure 4-49.
Screws
Screws
Earth plate
I/F bracket
Screws
Screws
C A U T I O N
When 2 Option I/F Boards have been installed, do not change the
installation positions of the Option I/F Boards. (Option Boards
are connected to CN4/CN5 card slots.)
C362DRV board
C362MAIN board
CN1
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com