Epson Stylus Pro 10000 - Removing the HEAD_SLIDE Sensor ASSY; Removing the HEAD_SLIDE Motor; Drive Gear

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 178
4.3.3.20 Removing the HEAD_SLIDE Sensor ASSY
1. Remove the R Side Cover as described in 4.3.1.4 "R Side Cover Removal".
2. Remove the Rear Cover as described in "Rear Cover Removal" 126.
3. Disconnect the harness for the HEAD_SLIDE Sensor ASSY from its connector
CN52 on the C362DRV board and take the harness out from the hole in the R Side
Frame.
Figure 4-152.
4. Remove the two screws (CP(W): M1.2x8) securing the HEAD_SLIDE Sensor
ASSY and remove the HEAD_SLIDE Sensor ASSY.
5. Release the harness for the HEAD_SLIDE Sensor ASSY from the cable clamps.
4.3.3.21 Removing the HEAD_SLIDE Motor / Drive Gear
1. Remove the R Side Cover as described in 4.3.1.4 "R Side Cover Removal".
2. Remove the Rear Cover as described in 4.3.1.7 "Rear Cover Removal".
3. Mark the secured location of PG Motor installation bracket.
Figure 4-153.
4. Disconnect the harness of the HEAD_SLIDE Motor and Slide Sensor from CN15 /
CN52 connectors on the C362DRV Board and take the harness out from the hole
in the R Side Frame.
Figure 4-154.
Screws
Head Slide Sensor
Marking the
securing position
Harness
(connected to
CN15 on the
C362DRV board)
HEAD_SLIDE
motor
Cable clump
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com