Epson Stylus Pro 10000 - I;H Cover ASSY Removal

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 125
4.3.1.6 I/H Cover ASSY Removal
1. Remove R Side Cover. (Refer to 4.3.1.4 "R Side Cover Removal".)
2. Remove two screws securing the R Inside Cover, then remove it.
Figure 4-19.
3. Remove three screws (Left side: one, Right side: two) securing the hinges.
Figure 4-20.
4. Opening I/H Cover by pushing the central upper part (the cover latch location) of
it, then remove I/H Cover with the hinge of the right and left.
5. Removing the E ring, then I/H Cover and slowing-down gear are separated.
Figure 4-21.
R inside Cover
Screws
Screws
C H E C K
P O I N T
When installing the “I/H Cover”, make sure the position of cover
latch and cover interlock are placed correctly with frame.
Figure 4-22.
I/C Holder Cover
E ring
Slow-down gear
Switch lever
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com