Epson Stylus Pro 10000 - Cutter

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Adjustment Self-Diagnostics 259
5.4.8.4 Cutter
Perform the cutter reliability test.
Perform the cut designated number at designated parameter.
When the reliability number is [-1], reliability is repeated until key is input.
When the reliability number is [-1], the biggest count number is 99,999,999 times
(within 8 column), and the count become 0 in the case that this is exceeded.
Figure 5-96 showing the cutter reliability test menu sequence.
Figure 5-96.

The maximum value of the page size is [3000mm].
 The maximum value of the reliability number designation is [99,999,999 times].
 The maximum value of the wait time is [999 seconds].
 There is the wait time that is designated whenever the cutter reliability test ends 1
time.
Enter
Soft Landing 1 : 80%
Soft Landing 2 : 60%
Soft Landing 3 : 40%
Soft Landing 4 : 60%
Soft Landing 5 : 40%
Paper Pre. 100%
Pressure 60%
1
Adjustable with "Paper Feed +/-"
key at unit of 1%
Adjustable with "Paper Feed +/-"
key at unit of 1%
Adjustable with "Paper Feed +/-"
key at unit of 1%
Adjustable with "Paper Feed +/-"
key at unit of 1%
Adjustable with "Paper Feed +/-"
key at unit of 1%
Adjustable with "Paper Feed +/-"
key at unit of 1%
Adjustable with "Paper Feed +/-"
key at unit of 1%
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Page Size 20mm
Life Count : -1
Wait Time(Sec).0
Count : 10
End : 50
1
Adjustable with "Paper Feed +/-"
key at unit of 1%
Adjustable with "Paper Feed +/-"
key at unit of 1%
Adjustable with "Paper Feed +/-"
key at unit of 1%
Enter
Enter
Enter
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com