Epson Stylus Pro 10000 - Roll Paper Cover Removal; Front Cover Removal

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 130
4.3.1.9 Roll Paper Cover Removal
1. Open the Roll Paper Cover.
2. Remove the upper and lower roll paper with roll shaft.
3. Remove two screws securing the Left Roll Holder and remove the Left Roll
Holder.
Figure 4-33.
4. Remove two screws securing the Right Roll Holder and remove the Right Roll
Holder.
Figure 4-34.
5. Remove the Guide Pin of right and left securing the Roll Paper Cover.
6. Remove the Roll Paper Cover.
4.3.1.10 Front Cover Removal
1. Remove the R Side Cover. (Refer to 4.3.1.4 "R Side Cover Removal".)
2. Remove the L Side Cover. (Refer to 4.3.1.5 "L Side Cover Removal".)
3. Remove the I/C Holder Cover. (Refer to 4.3.1.6 "I/H Cover ASSY Removal".)
4. Open the Front Cover.
5. Remove two hexagon screws on both side.
6. Remove two screws securing the Hinge Unit L.
Figure 4-35.
Guide pin
Screws
Guide pin
Screws
Hexagon screws
ScrewsHinge unit L
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com