Epson Stylus Pro 10000 - CR Steal Belt Tension Adjustment; PF Timing Belt Tension Adjustment

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Adjustment Mechanism Adjustment 195
5.3.1 CR steal belt tension adjustment
This adjustment is applied to all the operation accompanied by CR Motor/CR Steel
Belt removal and installation.
Standard: 100 g +/-10%
 Adjustment procedure
1. Push the CR Steel Belt center part (about midway the printing width (belt width))
upwards from below using a tension gauge.
2. Measure the tension when the CR Steel Belt touches the CR Rail.
3. Adjust the belt tension by equally turning the 2 CR Driven Pulley adjustment
screws (at left side frame).
4. Move the Carriage left/right several times by hand and check that the belt stays at
the center of the left and right pulleys. (No bias to one side.)
5. Apply a screw locking liquid to the adjustment screws.
Figure 5-1. CR steel belt tension adjustment
5.3.2 PF timing belt tension adjustment
This adjustment is applied to all the operation accompanied by PF Motor/PF Timing
Belt removal and installation.
Standard: 3,500 g +/-10%
 Adjustment procedure
1. Set the tension gauge in the position shown in Figure 5-2.
2. Pull the tension gauge in the direction shown by the arrow until it indicates 3,500g
± 10%.
3. Tighten the PF Motor set screws.
Figure 5-2. PF timing belt tension adjustment
C A U T I O N
Do not allow creases or end contact damage on belt.
CR driven pulley adjustment screw
CR driven pulleySteel belt
Screw
PF timing belt
Tension gauge
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com