Epson Stylus Pro 10000 - Write USB-ID; Resetting Counters; Mechanism Adjustment

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Adjustment Mechanism Adjustment 194
5.2.4 Write USB-ID
A "USB-ID" unique to the printer is registered in NVRAM of the printer C362DRV
Board. When the C362DRV Board is replaced, perform writing of the USB-ID.
This writing operation must be done with "EPSON Printer Adjustment Program
(MC10000.exe)."
Use a parallel (compatible) I/F connection.
NECESSARY EQUIPMENT

"EPSON Printer Adjustment Program" Filename: MC10000.exe
 PC with Windows 95/98
 Parallel I/F cable (compatible mode)
WRITING STEPS
1. Start "EPSON Printer Adjustment Program".
2. Select model name and port.
3. Click the writing radio button to begin.
5.2.5 Resetting Counters
Be sure to reset the specified counters when performing Execution Points shown in
Table 5-3. If these are not reset, Maintenance/Service Calls will not be cancelled.
5.3 Mechanism Adjustment
This section describes the mechanism adjustment required after replacing/removing
specific parts. The following table is shown about the parts for which adjustment is
required and the adjustment items.
Table 5-4. Mechanism adjustment item
Certain Parts Adjustment Item Required Tool Reference
CR Motor CR steel belt tension
Tension gauge: 200g
Code: 1047744
page 195
PF Motor PF timing belt tension
Tension gauge: 4,000g
Code: B747700300
page 195
P-Thick sensor
Self diagnostics/
Check "Paper Thickness"
page 196
Cutter Sub Platen position Adjustment tool: 1070178 page 196
Front cover Cover sensor position page 197
CR Encoder Encoder position Adjustment tool: 1070171 page 198
Print Head Print head slant page 198
Dot missing detector Offset adjustment page 199
Front sensor Paper Detect position Kimoto #300 tracing paper page 199
Rear sensor Paper Detect position Kimoto #300 tracing paper page 199
P_Edge sensor Paper Detect position
XEROX Bright recycle
paper
page 199
paper feeding
adjustment
page 200
Cutter pressure Cutter pressure Tension Gauge #F712 page 200
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com