EPSON Stylus Pro 10000/10000CF/10600 Revision D
Stylus Pro 10600 Product Description 318
8.1.2 Function
8.1.2.1 Operating Panel
Configuration of operation panel features (buttons, LED) is identical to Stylus Pro
10000/10000CF.
Panel Display
The table below shown the lists of the LCD Panel Display in the normal mode.
NOTE: (*1) When PG setting = "WIDE" "WIDEST", 20 th character is "H" on LCD.
When PG setting = "NARROW", 20 th character is "S" on LCD.
8.1.2.2 SelecType Settings
Panel Setting Mode is entered, operated and terminated by same methods used with the
Stylus Pro 10000/10000CF. (Refer to 1.6 "SelecType Settings")
The table below shown the SelecType Menus.
Table 8-4. Panel Display Messages
Functions LCD Panel Display 20th character
Ready to print
READY PG setting *1
Processing data / Printing
PRINTING PG setting *1
In power OFF sequence
POWER OFF -
In ink sequence
WAIT PG setting *1
Initial filling
INK CHARGING nnn% -
Ink drying
INK DRY NN MIN -
Pause
PAUSE -
Reset
RESET -
Initializing
WAIT -
Waiting for paper initialize start
trigger
PRESS PAUSE BUTTON -
Initializing paper
WAIT -
Out of paper
PAPER OUT -
Difference with roll paper and sheet
LOAD XXX PAPER -
Paper set lever is released
LOAD PAPER -
Paper jam
PAPER JAM -
Front cover open
FRONT COVER OPEN -
Paper cutting error
PAPER NOT CUT -
Paper not straight
PAPER NOT STRAIGHT -
Paper check error
RELOAD PAPER -
End of roll
PAPER OUT -
Problem with paper output (sheet)
RELOAD PAPER -
Paper is thick for cleaning
REMOVE PAPER -
Replacing ink cartridge
INK COVER OPEN -
Ink finished
INK OUT -
Ink low
INK LOW PG setting *1
No ink cartridge
NO INK CARTRIDGE -
Defective ink cartridge
DEFECTIVE INK CARTRIDGE -
Command error (P3 transport failure,
IK command. relate to MW)
COMMAND ERROR -
Type B interface error
OPTION I/F ERROR -
Fatal error
SERVICE. REQ. nn -
Maintenance required
(waste ink counter overflow etc.)
MAINTENANCE REQ. nn PG setting *1
Timer IC reset/NVRAM clear
WAIT -
Restarting required
TURN PWR OFF AND ON -
Replacing ink cartridge
INK COVER OPEN -
Ink cover open
CLOSE INK COVER -
Nozzle check error
NOZZLE CHECK ERROR -
Wrong ink cartridge (dye/pigment,
destination, black ink)
WRONG CARTRIDGE -
Non-genuine cartridge
INVALID CARTRIDGE -
Unable to clean (Thick paper)
REMOVE PAPER -
Unable to clean (not enough ink)
NOT ENOUGH INK -
Auto reload error
RELOAD PAPER -
Table 8-5. SelecType Menus
Menu Item LCD Panel Display Reference
Printer Setting Menu
PRINTER SETTING MENU
page 319
Test Print Menu
TEST PRINT MENU
page 321
Printer Status Menu
PRINTER STATUS MENU
page 323
User Paper Setup Menu
PAPER CONFIG. MENU
page 326
Maintenance Menu
MAINTENANCE MENU
page 327
Gap Adjustment Menu
HEAD ALIGNMENT MENU
page 329
Table 8-4. Panel Display Messages (continued)
Functions LCD Panel Display 20th character
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com
To Next Page
Loading...
