EPSON Stylus Pro 10000/10000CF/10600 Revision D
Stylus Pro 10600 Product Description 329
Gap Adjustment Menu
Selecting this mode allows the user to Bi-D and Uni-D adjustment for each paper
thickness.
Table 8-15 shown the gap ajustment menu.
NOTE1: Underlined values are the default settings.
NOTE2: (*1) When HC2/AY ink is set, it is not displayed. (Setup value is
default.)
NOTE3: (*2) When HC2/AY ink is set, actual operation will be different.
Setup method
1. Set the paper in place.
2. Select the gap adjustment menu from the panel.
3. Set to "STD" when using EPSON paper (0.2mm or 1.2mm thick). For other paper,
set thickness in units of 0.1mm.
4. Select paper group from A to C which is appropriate to the paper used for printing.
5. Select the adjustment pattern to be printed (Bi-D LC/Bi-D All/Uni-D (not
displayed on HC2/AY)), and print. (Display is indicated as PAT. PRINTING)
6. Check the printed adjustment patterns and enter the number of the pattern with the
least displacement for each adjustment item. (Refer to Figure 8-4)
7. Repeat step 5 ~ step 6 until adjustment of all items is completed.
Figure 8-4. Gap Ajustment print pattern
Table 8-15. Gap Ajustment Menu
LCD Panel Display Setup Values Notes
PAPER THICK
STD,
0.0~1.6mm
Select the thickness, to 0.1mm, of the paper you
are using to check the platen gap. Normally,
leave set to Standard.
PAPER GROUP *1 A, B, C
Paper group select
ALIGNMENT *2
Bi-D LC
,
Bi-D ALL,
Uni-D (*1)
Selects which patterns to print.
(All patterns or selected patterns only.)
#1 LC 1~8~15
Bi-D adjustment LC (240cps, VSD1)
#2 LC 1~8~15
Bi-D adjustment LC (300cps/240cps, VSD2)
#1 K 1~8~15
Bi-D adjustment all colors
(240cps, VSD1) All 6 colors
~
~
#1 Y 1~8~15
#2 K 1~8~15
Bi-D adjustment all colors
(300cps/240cps, VSD2) All 6 colors
~
~
#2 Y 1~8~15
#1 C 1~8~15
Uni-D (240cps, VSD1)
All 5 colors
~
~
#1 Y 1~8~15
#2 C 1~8~15
Uni-D (300cps/240cps, VSD2)
All 5 colors
~
~
#2 Y 1~8~15
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com
To Next Page
Loading...
