Epson Stylus Pro 10000 - Removing the Suction Fans

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 145
4.3.3.2 Removing the Suction Fans
1. Remove the H Top Cover.
2. Remove the Right and Left Side Cover.
3. Remove the Rear Cover.
4. Move the Head Carriage to the home position.
5. Remove three screws (M3x8) on the clamp securing the Head Carriage and tubes
to the Guide Rail.
6. Unlock the tube clamp from Guide Rail.
7. Remove four screws (M3x8) on the Guide Rail.
8. Remove the Guide Rail.
Figure 4-67.
Guide rail
Screws
Clamp
Tube clamp
(Front side view)
(Left side view)
Screws
Metal Clamp
Marking
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com