EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 133
4.3.2 Circuit Board Removal
This section explains how to remove the Power Board, the HJFK / Dummy Board, the
C362MAIN Board, the CSIC Board, the C362DRV Board and the P/S Fan.
4.3.2.1 Power Board Removal
1. Remove the Rear Cover as described in 4.3.1.7 "Rear Cover Removal".
2. Remove the two cables connected to the Power Board as shown below.
Figure 4-41.
3. Disconnect the P/S Self-containing Fan connector connected to CN39 on the
C362DRV board.
Figure 4-42.
4. Remove the four white screws (CPS: M3x8) securing the Power Board, and then
remove the Power Board.
Figure 4-43.
W A R N I N G
Unplug the AC power cable and wait at least five minutes before
removing the power board to make sure there is no residual power
left in the board’s condensers.
Table 4-3. Power Board Connectors
Connector # Pins Color Connection Notes
CN2 3 BIK/R/ORG C362DRV Board CN56
CN4 12
YEI/BRN/RED/
BIU/ORG/BIK
C362DRV Board CN40
CN2
CN4
P/S Self-containing
Fan
Disconnect cable connector
Screw
Screw
Screw
Screw
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com
To Next Page
Loading...
