Epson Stylus Pro 10000 - Troubleshooting Using the Error Messages; Status Reply Priority

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Troubleshooting Troubleshooting Using the Error Messages 81
3.2 Troubleshooting Using the Error Messages
This machine does the self diagnosis on the basis of the detection condition in each
sensor and detect abnormal condition with the result and do the display of error
condition by the error message and indicator.
This table separates problems into errors that can be corrected by the user (Warnings/
Errors) and errors that must be corrected by a service engineer (Fatal Errors, Section
3.3).
3.2.1 Status Reply Priority
Table 3-1. Status Reply Priority
Prioyity Status
High Fatal errors / Restarting required
Paper jam
During power OFF sequence
Reset, timer IC reset/NVRAM clear
During ink cartridge replacement
Paper set lever is released
Front cover open
Type B interface error
Ink cover open
No ink cartridge
Wrong ink cartridge (dye/pigment)
Non-genuine cartridge
Ink end
Difference in setup for roll paper/sheet
Command error
Paper cutting error
Paper not straight
Paper check error
Roll paper end
Paper output error
Nozzle check error
Initializing
During ink sequence
Waiting for paper initialization trigger
Panel setup
During pause
During paper initialization
Busy
During ink drying
Maintenance request
Ink cover open
Ink end error
Ink low / Maintenance required
Printing
Processing data / print ready
Out of paper
Low Idle
Table 3-1. Status Reply Priority
Prioyity Status
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com