Epson Stylus Pro 10000 - P;S Fan Removal

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 140
4.3.2.6 P/S Fan Removal
1. Remove the Rear Cover as described in 4.3.1.7 "Rear Cover Removal".
2. Disconnect the P/S Fan Cable connector that is connected to C362DRV Board
CN41 and release the cable clamp.
Figure 4-55.
3. Remove one screw securing the earth plate connected to CN42 on the C362MAIN
board, and disconnect fan cable connector.
Figure 4-56.
4. Remove one screw securing the P/S Fan Holder, then remove it.
Figure 4-57.
5. Remove two screws securing the P/S Fan on the P/S Fan Holder, and remove it.
Figure 4-58. AC Inlet Removal
Cable Connector
Cable Clump
Connector
Auto take-up roller connector
Screw
One screw securing the P/S Fan Holder
P/S Fan Holder
Fan screws
P/S Fan Holder
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com