EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 139
Figure 4-53.
4. Remove nine screws (CP(W): M3x6) securing the C362DRV Board and remove
the board.
Figure 4-54.
(Power Board area)
(C362DRV Board area)
(C362MAIN Board area)
Clamp location
Screws
Screws
Screws
Screws
Lithium battery
C A U T I O N
Be sure NOT to remove the C362DRV Board without removing
the C362MAIN Board in advance. Otherwise, the chip
components on reverse side of the board should be damaged if
dragging the boards on the studs.
Because the board is installed at an angle, use caution when
removing screws because removing all screws could allow the
board to fall and damage chips.
When an FFC type cable is removed/inserted into the connector
on the C362DRV Board, be sure to perform the action
perpendicular to the connector. (Angled removal/insertion can
damage the cable contacts, causing short-circuit/line breakage
and destruction of components on the board.)
Lithium battery (CR2032: 3V) is installed on the C362DRV
board. Do not short-circuit the C362DRV board with metal or
conductive materials.
A D J U S T M E N T
R E Q U I R E D
When replacing the C362DRV Board, be sure to perform all the
required adjustments described in Chapter 5 ADJUSTMENT to
ensure proper operation, as the memory on the C362DRV Board
retains various parameters for each mechanism-specific control
and operating history of the printer.
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com
To Next Page
Loading...
