EPSON Stylus Pro 10000/10000CF/10600 Revision D
Operating Principles Printer Mechanism Components 75
2.2.7 Others
COVER SENSOR
The cover sensor switch is attached in cover open and close department, to detect the
open and close condition of the front cover and I/C holder cover where it is attached on
the front side of this machine.
This sensor is doing the operation/halt control of the CR motor and PF motor drive
circuit through the C362DRV board logic circuit after cover condition detection with
the sensor. This control is similar even when the paper hold lever is in cancellation
condition.
Figure 2-15. Cover sensor / Panel unit
CIRCUIT BOARD PLACEMENT
There are the panel unit on surface right of this printer, and Power supply circuit board
and C362MAIN board, HJFK board, C362DRV board, circuit board in back
compartment of this printer.
Figure 2-16. Circuit board placement
Front cover detect SW-L
Front cover detect SW-R
IC holder cover SW
Power boardC362DRV board
HJFK board
C362MAIN board
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com
To Next Page
Loading...
