Epson Stylus Pro 10000 - Rear Sensor Position

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Adjustment Self-Diagnostics 241
5.4.4.14 Rear sensor position
This adjustment to detect the form length of cut paper precisely. The position of rear
sensor inside firmware is adjusted on the basis of the nozzle to secure the maximum
Pause range from the paper edge. Set the A3 cut sheet paper in direction of side put and
cause a horizontal line (1 of dot line of black) printing in the place of 14 mm from the
paper edge and measure the length of it from edge then input the value revision. This
adjustment is not necessary at the field even if band correction is performed, although
this item is necessary in a production process. Cut sheet is required without the
condition of cut sheet placement when this item is selected. Figure 5-69 showing menu
sequence and Figure 5-70 showing print pattern.
Figure 5-69.

Measure the length between the paper edge to printed line and input the rear sensor
position.
Shift to the "Test print" by pressing "Enter" key during the "Rear sensor" display.
Figure 5-70.
Eject the sheet after the
printing.
Enter
Please Set Cut Sheet
Printing Pattern
Paper Width xxx.xmm
Rear Sen. Pos. : xx.xmm
Shift to the "RearSen.Pos.:xxmm"
with "Pause" key.
Adjust the position with unit
0.1mm by "Paper feed+/-" key.
Print END
Enter
Rear sensor position
correction
Paper Feed
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com