Epson Stylus Pro 10000 - Removing Paper Guide U

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 131
7. Remove the Hinge Unit L with Hinge.
8. While supporting the Front Cover, lower the left side and slide to left, then remove
the Front Cover.
4.3.1.11 Removing Paper Guide U
1. Remove the H Top Cover as described in 4.3.1.3 "H Top Cover Removal".
2. Remove the Rear Cover as described in 4.3.1.7 "Rear Cover Removal".
3. Remove the six screws (CS: M4x8) securing the Paper Guide U.
Figure 4-37.
C A U T I O N
 When removing / installing, hold the “Front Cover” with your
hand and do not drop it.
 When installing the "Front Cover", make sure the shape of
cover springs. (Shape are different with right and left.)
 Confirm the movement of the cover and operation of the cover-
open sensor (mounted inside of right hinge unit).
 When installing, make sure the shape (D cut) of shaft on the
both hinge unit then align the shaft hole on the Front Cover.
Figure 4-36.
Hole
S
h
a
f
t
Front Cover
Hinge unit
(Right side view)
Paper Guide U
(Right-Rear side view)
(Left-Rear side view)
Screws
Screws
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com