Epson Stylus Pro 10000 - Cleaning Device Section

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Operating Principles Printer Mechanism Components 70
2.2.3 Cleaning device section
Cleaning device department is built to a certain cleaning unit on the right the main
frame. The waste ink from the cleaning device department is sent to the waste ink tank
of the lower right through this three thin tubes and one pipe. (Refer to following
figure.)
Figure 2-12. Cleaning device department
The structure of the cleaning unit is shown in the next figure.
Figure 2-13. Cleaning device department expansion
The explanation of the cleaning device department main component is as follows.
 Pump assembly
By driving the pump through the cap (close), ink suck from the head nozzle.
Usually ink suck, ink early period fill, cleaning etc. are run. The waste ink from
the pump is sent to the waste ink tank through three lane pipes.
 Head vacuum cleaner
Combining the tension of rubber and felt. Wiping ink and garbage etc. adhered to
the head nozzle face it drops it.
Cleaning unit
Waste ink tank
M
M
Cleaning unit
Waste ink tank
Cap motor
Cap
Print head
Creaner head
Pump
CR
guide
rail
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com