Epson Stylus Pro 10000 - Page 184

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 177
6. Remove right side two screws (M4x6) and front upper side two screws (M4x6),
then remove the Paper Hold Solenoid with bracket.
Figure 4-149.
7. Remove one screw (M3x6) securing solenoid armature.
8. Remove two screws (M3x6) securing solenoid coil, then remove the Paper Hold
Solenoid.
Figure 4-150.
Paper hold solenoid
Screws
Screws
(Right side)
(Front upper side)
Screws
Screw for armature
C H E C K
P O I N T
When installing the Paper Hold Solenoid, make sure the lock lever
move smoothly. Otherwise loosen the armature screw and secure it
again.
Figure 4-151.
Look lever
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com