Epson Stylus Pro 10000 - Page 188

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 181
4. Remove the Paper Guide L as described in 4.3.1.8 "Paper Guide L Removal".
5. Open the Front Cover, then remove two screws (M1.2x8) securing P_FRONT
Sensor to the bracket.
Figure 4-161. 2 Screws Securing the P_FRONT Sensor
6. Close front cover. Release P_FRONT Sensor harness from cable clamp, then
remove P_FRONT Sensor from printer.
Figure 4-162. P_FRONT Sensor Removal
C H E C K
P O I N T
Use a No. 2 bit screwdriver when removing P_FRONT Sensor
screws.
Screws
P_FRONT sensor
A D J U S T M E N T
R E Q U I R E D
If you replace the P_FRONT Sensor ASSY, perform the necessary
adjustment listed in Chapter 5.
Cable clump
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com