Epson Stylus Pro 10000 - Page 180

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 173
5. Disconnect the cable for the Panel Unit from the cable clump on the Dot Missing
Detector.
Figure 4-138. View from upper surface rear
6. While supporting the Dot Missing Detector unit from the rear by hand, remove 2
screws (M4x8) securing the Dot Missing Detector unit to the CR Guide Rail, then
remove the Dot Missing Detector unit.
Figure 4-139.
Cable clump
Cable for the
panel unit
Dot missing
detector
CR Guide rail
Screw
C A U T I O N
Use a magnetic tip screwdriver when removing/installing screws
and be careful of the following points.
1. Do not drop screws inside CR Guide Rail. (Difficult to see
inside rail.)
2. Do not scar the steel belt.
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com