Epson Stylus Pro 10000 - Page 150

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 143
2. Remove the Handle of one place by pressing latches.
Figure 4-61.
3. Remove 2 ink tubes from the waste ink tube retainer plate.
Figure 4-62.
4. At the bottom side, pull (unlock) the two tabs of Ink Box and slide the Ink Box toward you.
(Rear side)
Figure 4-63.
C A U T I O N
After the 2 ink tubes have been removed, insert an ink absorbent
material into the ends of the tubes to prevent ink leakage.
Handle
Latch (both side)
Connect to the flushing box.
Connect to the pump ASSY.
(Front side view)
(Bottom side view)
Tab
(Top side view) (Bottom side view)
(Bottom side view)
Tab
Tab
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com