Epson Stylus Pro 10000 - Page 168

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 161
5. Disconnect the connector cable from Head Board, and remove two screws
securing Cutter Unit, then romove the Cutter Unit.
Figure 4-108.
Figure 4-109.
Cutter
Cable
Screws
Cutter edge
A D J U S T M E N T
R E Q U I R E D
 When installing cutter unit, use the L-shaped gauge to adjust the
position in relation to the sub-platen. (Refer to Chapter 5
"Adjustment," section 5.3.4)
 Adjust cutter pressure. (Refer to Chapter 5 "Adjustment,"
section 5.3.10)
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com