Epson Stylus Pro 10000 - Page 175

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 168
3. Remove four serews securing the PF Base.
Figure 4-125.
4. Remove the Grid Spacer and the Grid End.
Figure 4-126.
5. While holding down the PF Encoder from inside, remove two screws and remove
the PF Encoder.
Figure 4-127.
PF base
Screws
Grid end
Grid spacer
C A U T I O N
 When assembly, attach the PF encoder after plug the Scale, PF to
the sensor department of the PF encoder.
 Do not scars and touching the Scale, PF.
 When assembly, attach the grid end after two places of bosses are
combined with the hole of the PF base.
 The grid spacer have to be set to the direction that has a ditch
side.
Screws
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com