Epson Stylus Pro 10000 - Page 177

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 170
7. While supporting the Pump Cap Unit from the rear by hand, remove 2 screws
(M4x8) securing the Pump Cap Unit to the CR Guide Rail.
Figure 4-131.
C A U T I O N
 Use a magnetic tip screwdriver when removing/installing screws
and be careful of the following points.
1. Do not drop screws inside CR Guide Rail. (Difficult to see inside
rail.)
2. Do not damage steel belt.
 Do not touch the cleaner head and the cap.
Figure 4-132.
CR Guide rail
Cleaning Unit
Screws
Bracket
Cap motor
Cap
Cleaner head
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com