Fagor CNC 8065 - Page 104

Operating manual.
CNC 8060
CNC 8065
4.
AUTOMATIC MODE
Tool inspection.
·104·
(REF: 1807)
point of the interrupted block. The interrupted program assumes the changes from the
next block on.
• The CNC cancels functions G200 and G201 (manual intervention); it restores them when
resuming execution after tool inspection.
In general, all the changes made in MDI/MDA mode are kept active when resuming the
program after tool inspection except the following functions that are restored at the time of
interruption.
• The CNC restores the type of interpolation G00, G01, G02, G03, G33 or G63 that was
active at the time of the interruption.
• The CNC restores function G90 or G91 that was active at the time of the interruption.
• The CNC restores the status of function #MCS that was active at the time of the
interruption.
Repositioning the axes and the spindle.
To complete the tool inspection and before resuming the execution of the program, the
spindle turning direction must be restored and the axes repositioned. The vertical softkey
menu offers two options.
After selecting one of these two options, the vertical softkey menu shows a list of axes that
are out of position. If the status of the master spindle has changed during the inspection,
the softkeys will show the M3, M4, M5 or M19 function to restore.
Repositioning the axes.
The CNC allows repositioning the axes either one by one or in groups. Use the vertical
softkeys to select the axes to be repositioned and press [START]. The CNC will reposition
the axes at the selected point (according to the softkey selected earlier) at the feedrate set
by the machine manufacturer. Once one axis has reached its position, it will no longer be
available.
The movement of the axes may be interrupted with the [STOP] key, after which it is possible
to jog the axes using the jog keyboard. After interrupting a movement, it is necessary to select
again the axes to be repositioned.
Repositioning the master spindle.
The spindle turning status may be restored either together with the repositioning of the axes
or separately. The same vertical softkeys will show the M3, M4, M5 or M19 to be restored.
If the spindle was interrupted in a positioning with M19, repositioning will complete that
positioning. Once the spindle has recovered its status, it will no longer be available.
Canceling repositioning.
The CNC admits the possibility to end tool inspection before it is completed; i.e. without
having repositioned all the axes. The vertical softkey menu, next to the list of axes, shows
the following softkey to cancel repositioning.
Softkey. Reposition point.
Repositioning the axes at the interruption point.
Repositioning the axes at the starting point of the interrupted
block.
If the execution is interrupted during a polynomial interpolation (#POLY), the axes must be repositioned
to the beginning of the interrupted block in order to be able to redo the same path.
i
Softkey. Meaning.
Canceling repositioning.