Operating manual.
CNC 8060
CNC 8065
4.
AUTOMATIC MODE
Display the status of the DMC (Dynamic Machining Control).
·114·
(REF: 1807)
Vertical softkey menu.
DMC options.
4.9.2 Learning phase.
Every time #DMC ON is programmed without target power (PWRSP command), DMC
determines it through a learning phase that it initiates automatically. Once said value is
obtained, the normal DMC operation will begin.
With the axes in movement, the learning phase begins once DMC detects the entry into the
part. DMC waits for the feedrate to reach the programmed value, and during the movement
of the axes, it calculates the target power ("power consumed" – "no-load power"). The
learning phase has a one minute duration, starting from when the tool enters the part at a
distance equal to the radius. If the tool exits the part, it ceases counting the time until the
tool re-enters the piece.
Softkey. Meaning.
DMC options (dropdown menu).
• Repeat the DMC learning phase.
• Deactivating the DMC.
Softkey. Meaning.
This softkey allows the DMC learning phase to be repeated at any time,
as long as the DMC is active.
This softkey allows the DMC to be deactivated.
This softkey allows the DMC to be reactivated.
The learning phase can be repeated at any time,
while the DMC is active, by pressing the "DMC
learning" softkey in the automatic mode. After
pressing the softkey, while the DMC is active,
the next entry into the part will begin a learning
phase, whether or not the target power had been
programmed while activating the DMC.
To Next Page
Loading...
