Fagor CNC 8065 - Select the First and Last Blocks of the Execution

Operating manual.
CNC 8060
CNC 8065
4.
AUTOMATIC MODE
Program simulation and execution.
·90·
(REF: 1807)
4.3.2 Select the first and last blocks of the execution.
After selecting the "block selection" softkey, the horizontal softkey menu shows the following
options.
Set beginning.
This option sets as starting block for execution the block selected with the cursor. When not
setting the starting block, the program will begin executing from the first block.
The first block may be selected using the cursor or the "Find text" option of the softkey menu.
The selected block stays active until canceled (selecting another block or selecting the same
one again) or executing the program.
Stop condition.
This option sets the block where the execution of the program or subroutine will be
interrupted. After executing that block, the execution may be resumed with the [START] key
or canceled with the [RESET] key. If the last block is not set, the program execution will end
executing one of the end-of-program functions "M02" or "M30".
Select subroutine.
This option selects the stop condition in a global subroutine which has been called upon from
the program. When selecting this option, the CNC shows a list of the available subroutines.
After selecting the desired subroutine, it will appear in the program window.
Set stop block.
This option sets as execution interruption block the block selected with the cursor. If the last
block is not set, the program execution will end executing one of the end-of-program functions
"M02" or "M30".
The last block may be selected using the cursor or the "Find text" option of the softkey menu.
The selected block stays active until canceled (selecting another block or selecting the same
one again) or executing the program.
Number of times.
This option sets as stop condition, that the block selected as the last block has been executed
a specific number of times.
When selecting this option, the CNC requests the number of times that the block must be
executed before ending the execution of the program. After entering the number of times,
press [ENTER] to validate the value or [ESC] to cancel it.
Softkey. Description.
Set beginning First block for execution or for manual block search.
Stop condition. Set the condition to end the execution or the manual block
search.
Automatic block search. Do an automatic block search.
Manual block search. Do a manual block search.
Find text. Find text