Operating manual.
CNC 8060
CNC 8065
21.
MACHINE PARAMETERS
Operations with tables
·394·
(REF: 1807)
21.3 Operations with tables
21.3.1 Data editing and validation
Use the softkey menu to select the desired machine parameter table. To edit the table data,
proceed as follows:
1 Use the cursor to select the parameter whose value is to be set.
2 Key in the desired value. If [SUP] is pressed, the parameter will assume the default value.
3 Press [ENTER] to accept the new value or [ESC] to ignore the new value and recover
the previous one.
Parameter types
Certain parameters can only assume specific values. These parameters will be identified as
follows.
Depending on the type of values they can assume, they will be defined as follows:
• If the parameter may assume a value between specific limits, enter the desired value.
If the value exceeds those limits, the parameter will assume its default value.
• If the parameter contains a list of options, press [ENTER] to display the drop list and select
one of those options.
• If the parameter refers to a file, press [ENTER] and the CNC will show the list of available
files.
Data validation.
The parameter has a list of options.
The parameter refers to a file.
After editing or modifying the table data, the new values must be validated so they are
assumed by the CNC. To validate the data, press the VALIDATE softkey. To validate certain
parameters, restart the CNC. These parameters will be identified with the following symbol
next to their name:
Restarting the CNC required.
To Next Page
Loading...
Need help?
General
