Fagor CNC 8065 - Softkey Menus. Options of the Cross Reference Service

Operating manual.
CNC 8060
CNC 8065
20.
PLC
"Cross references" service
·376·
(REF: 1807)
20.11.1 Softkey menus. Options of the "Cross reference" service.
When accessing the "Cross reference" service, the softkey menu will offer the following
options:
Inputs
Show information about the inputs.
Outputs
Show information about the outputs.
Marks
Show information about the marks.
Registers
Show information about the registers.
Timers
Show information about the timers.
Counters
Show information about the counters.
Print
It is used to print the cross reference tables out to a printer connected to the CNC or as a
"*.PRN" file at the CNC. When printing to a file, it is saved in the folder:
"C:\Cnc8070\Users\Reports\*.prn"
When selecting this option, the CNC shows a dialog box requesting the destination for the
file (printer or file). When printing to a file, it is possible to select the name and location of
the file. After selecting the destination, press [ENTER] to print the table or [ESC] to cancel it.