Operating manual.
CNC 8060
CNC 8065
MANUAL (JOG) MODE
5.
Tool selection and tool change
·127·
(REF: 1807)
5.4 Tool selection and tool change
The tool located in the spindle may be changed in manual mode. Proceed as follows.
1 Press [T] at the alphanumeric keyboard. The CNC will highlight the current tool indicating
that it is selected.
2 Key in the number of the tool to be placed in the spindle.
3 Press [START] to execute the tool change or [ESC] to cancel the operation.
To Next Page
Loading...
