Fagor CNC 8065 - Version History - CNC 8065

Operating manual.
CNC 8060
CNC 8065
·25·
(REF: 1807)
VERSION HISTORY - CNC 8065
Here is a list of the features added to each manual reference.
Ref. 1103
Ref. 1201
Ref. 1209
Ref. 1301
Ref. 1305
Ref. 1308
Ref. 1309
First version.
Software V04.22
Automatic mode. Display the line number in execution.
Automatic mode. Display the line number where execution was interrupted.
Automatic mode. Resume the execution of a program from the block where it was canceled.
Automatic mode. While G95 active, the feedrate is shown in mm/turn.
Jog mode. While G95 active, the feedrate is shown in mm/turn.
User tables. Set the absolute zero offsets with a coarse part and a fine part.
User tables. Display the incremental zero offset (G158) in the zero offset table.
User tables. The zero offset table highlights in color the active offset, both absolute and incremental.
User tables. The clamp table highlights in color the active clamp.
User tables. Calculator assistance to set the data of the zero offset table.
User tables. Calculator assistance to set the data of the clamp offset table.
Tool tables. For the grooving and cut-off tool, the table assumes the values A=90, C=90 and Rp=0.
HD graphic environment. Select the simulation speed in the graphics window.
Software V04.24
Automatic mode. Cancel the execution and resume from another block while keeping the history.
Automatic mode. The CNC shows the percentage of the program that has been executed.
Software V04.25
Automatic mode. The "Main plane" simulation type does not send the M-H-S-T functions to the PLC.
Utilities mode. New backup-restore.
Software V04.26
Calculator. In jog or conversational mode, when calling the calculator with a field selected (F, S, etc), the calculator shows the value
of that field.
The CNC either shows or hides the softkey for toggling the display between mm and inches depending on the setting of machine
parameter MMINCHSOFTKEY.
Automatic mode. Programs with ".mod" extension may be modified when they are interrupted using "cancel and resume".
Software V04.26.10
Every time [START] is pressed, the CNC checks that the room temperature does not exceed 65 ºC (149 ºF) and, if it does, the CNC
does not let run the program and issues the corresponding error message.
Software V04.27
MDI/MDA mode. The [ENTER] key does not pop up block history.
Tool inspection allows accessing manual tool calibration.