CNC 8060
CNC 8065
5
·117·
(REF: 1807)
MANUAL (JOG) MODE
When accessing the jog mode from the automatic mode, the CNC keeps the machining
conditions selected in the last mode.
The channel does not allow accessing its manual mode if a program is being executed in
the same channel or a block is being executed in MDI/MDA mode. If the execution of the
program has been interrupted, the CNC will cancel the execution of the program and will go
into jog mode. A program is interrupted when the [STOP] has been pressed or is waiting in
single-block mode.
5.1 Interface description.
Description of a typical screen of this work mode.
A typical screen of the jog mode can show the following information:
A Information related to the position of the axes. In the screen configuration supplied by
Fagor, the data displayed will be different on each screen.
The most common thing is to show the current position of the axes referred to part zero
in large characters, and the amount of following error (axis lag) in small characters.
Another more detailed option shows the coordinates of the tool tip and those of the tool
base, being both referred to part zero and machine zero.
If the name of the axis appears in red, it means that the PLC is inhibiting the movement
of the axes (INHIBIT mark active).
B Active "M" functions.
C Active "G" functions and high-level commands.
In handwheel mode, this symbol next to an axis indicates that the axis has an
individual handwheel associated with it.
To Next Page
Loading...
