Operating manual.
CNC 8060
CNC 8065
UTILITIES MODE
19.
Protection passwords
·335·
(REF: 1807)
19.5 Protection passwords
The passwords may be used to define each of the codes that the user will have to enter in
order to access certain CNC functions. If entered correctly, it stores it and it does not request
it again unless the CNC is turned off. If the password is wrong, the requested action cannot
be carried out and it requests it again every time.
In a CNC with a write-protected disk, when the CNC is powered up in setup mode, it does
not request the protection passwords. When the CNC is powered up in user mode, it requests
the protection passwords.
How to set the protection passwords
Press the "Passwords" softkey to access the password setting screen. From this screen, it
is possible to define, modify or delete the passwords. If this screen is protected, pressing
the softkey will request the general password.
Each password may be up to 10 ASCII characters long. It is case sensitive.
The "Delete all" softkey deletes all the passwords defined.
Description of protection passwords.
General password
It is requested when trying to access this password setting screen.
PLC
It is requested when trying to carry out the following actions at the PLC:
• Editing the PLC program. When entering the wrong password, the PLC program opens
as read-only.
• Adding a file to the project.
• Deleting a file.
• Renaming a file.
• Editing PLC messages. When entering the wrong password, the PLC messages may
be neither displayed nor edited.
• Generate PLC.
• When accessing to the "Commands" service options.
• In monitoring, when modifying the status of a resource.
Machine parameters
The CNC requests a password when attempting to carry out the following actions:
• Modifying the value of a parameter.
• Initialize a table.
• Loading a table.
• When starting the CNC application and the unit is powered up in setup mode.
• Do a restore of the CNC data.
Customizing
It is requested when entering the FGUIM application. When entering the wrong password,
it will not be possible to access the application.
To Next Page
Loading...
