Operating manual.
CNC 8060
CNC 8065
22.
SETUP ASSISTANCE
Oscilloscope
·400·
(REF: 1807)
22.1 Oscilloscope
The oscilloscope is an assistance tool for adjusting the CNC and the drives and can
graphically show 4 previously selected variables, modify their values and check the different
responses of the system. Together with the circularity test and the bode diagram, the
oscilloscope helps speed up and simplify the machine setup process.
Using the oscilloscope, it is possible to edit the CNC's machine parameters that affect the
adjustment; it is also possible to modify at the Sercos drives the variables that have writing
permission and it is possible to change the variables and parameters at the Mechatrolink
devices (Mlink-II). In any case, a protection password is required for modifying the CNC's
machine parameters or the variables of a Sercos drive.
The oscilloscope is an assistance tool that only shows the response of the system to the
various settings (adjustments); it is up to the technician to choose the best adjustment.
The oscilloscope function requires Sercos communication and a drive version V06.01 or later.
Otherwise, the CNC will show the error "Access denied".
The oscilloscope function is not available with the ACSD drives.
To Next Page
Loading...
