Fagor CNC 8065 - Working in the Editing Window

Operating manual.
CNC 8060
CNC 8065
8.
EDISIMU MODE (EDITING AND SIMULATION)
Working in the editing window.
·170·
(REF: 1807)
8.4 Working in the editing window.
8.4.1 Select a program.
The "Open program" softkey is used to select a program in EDISIMU mode and may be a
new program or an existing one. A different program may be edited and executed in each
channel. When selecting this option, the CNC shows a list of the available programs. See
"3.7 File selection window" on page 78.
To select a program from the list:
1 Select the folder that contains the program. If it is a new program, it will be saved in this
folder.
2 Select the program from the list or write its name in the bottom window. To edit a new
program, write the name of the program in the lower window and the CNC will open an
empty program or a predefined template depending on how the editor is configured. See
"8.4.6 Customizing the editor (general options)." on page 173.
3 Press [ENTER] to accept the selection and open the program or [ESC] to cancel it and
close the program listing.
8.4.2 Operations with blocks. Cut and paste.
The "Operations with blocks" softkey is used to copy, cut and paste the information of a block
or set of blocks and export this information as an independent program. This option is only
available when there is a text selected in the program or on the clipboard. To select a text
in the program, keep the [SHIFT] key pressed while moving the cursor.
Operations with blocks "Copy"
Copy the selected text onto the clipboard.
Operations with blocks "Cut"
Copy the selected text onto the clipboard and deletes it from the program.
Operations with blocks "Paste"
Paste the contents of the clipboard into the program.
Operations with blocks "Copy to program"
Save the selected texts as an independent program. When selecting this option, the CNC
shows a list of the available programs. To save the text as a program:
1 Select the destination folder.
2 Define the file name at the bottom window. To replace an existing file, select it from the list.
3 Press [ENTER] to save the program or [ESC] to cancel the selection and close the
program listing.