Operating manual.
CNC 8060
CNC 8065
GRAPHIC ENVIRONMENT (MILL MODEL)
12.
Type of graphics
·225·
(REF: 1807)
12.2 Type of graphics
When selecting this option, the softkey menu shows the types of graphics available. The
various types of graphics may be line (3D lines, XY, XZ, YZ and Combined) or solid (Sections
and 3D solid). Line graphics show the tool path with lines of different colors and solid graphics
show an image of the part.
The type of graphics selected will remain active until another type is selected or the graphic
display is deactivated or the CNC is turned off. Likewise, when changing the type of graphics,
the CNC will maintain the graphic conditions (zoom, graphic parameters, display area, etc.),
defined for the last graphic.
"3D lines" Graphics
This type of graphics displays a three-dimensional graph of the tool paths.
"Sections" Graphics
This type of graphic displays a top view (XY plane) of the part; it shows the machining depths
in different tones. It also displays the XZ and YZ sections for the areas shown by the indicators
of the top view.
These indicators may be moved around using the [
][][][] keys, to display the different
sections of the part. The CNC shows dynamically the new section being selected.
The indicators may be moved at any time even while executing the program.
"XY" - "XZ" - "YZ" graphics
This type of graphic displays the tool paths in the XY, XZ or YZ plane.
"Combined" graphics
This type of graphic divides the display area in four quadrants and displays the tool path
corresponding to each plane XY, XZ, YZ and to the 3D view.
"Solid 3D" Graphics
This type of graphics displays a three-dimensional graph of the machining of the part.
Starting out with a 3D block which is "machined" as the program is executed or simulated.
To Next Page
Loading...
