Operating manual.
CNC 8060
CNC 8065
18.
TOOL AND MAGAZINE TABLE
Tool table (simple mode).
·312·
(REF: 1807)
18.4 Tool table (simple mode).
The tools in the table appear sorted by the magazine they belong to starting from the first
magazine and leaving the ground tools for last. The tools of a magazine are sorted by tool
number and by offset number.
18.4.1 Vertical softkey menu.
The options shown for the tool table are.
18.4.2 Configuring the tool data display
The data being shown in the tool table may be set up in the full tool table from the vertical
softkey menu.
Softkey. Description.
Change the units for data display. The softkey highlights the units currently selected
(millimeters or inches).
The selected units are only valid for displaying data. For programming, the CNC assumes
the units defined with the active function G70 or G71, or, when not programmed, the units
set by the machine manufacturer (INCHES parameter).
The CNC will display this softkey or not depending on how machine parameter
MMINCHSOFTKEY has been set.
The CNC is showing milling tool information (standard page or offsets); this softkey shows
the information of the turning tools.
The CNC is showing turning tool information (standard page or offsets); this softkey
shows the information of the milling tools.
Show the standard page (screen) of the tool table. The standard page (screen) shows
the main data of the tools.
Show the offset page (screen) of the tool table. The offset page (screen) shows the offsets
of the tools.
Softkey to access the setup panel of the tool table. When pressing this softkey,
the CNC shows a dialog box to carry out the following actions.
• Select the data to be shown in the tool table. To show or hide a data, activate
or cancel its check box.
• Define whether the wear is entered either with an incremental or with an
absolute value.
To Next Page
Loading...
