Operating manual.
CNC 8060
CNC 8065
8.
EDISIMU MODE (EDITING AND SIMULATION)
Working in the editing window.
·172·
(REF: 1807)
8.4.5 Operations with files.
The "File" softkey is used to recall, save or print the program as well as import dxf, pit or pim
files.
File "Restore original"
This softkey is used to recover the original file without the changes made since the last time
it was opened. When selecting this option, the CNC requests confirmation of the command.
In programs larger than 2MB, the editor does not offer the option to recover the original
program.
This option is only available when the "auto save" option is active. See
"8.4.6 Customizing
the editor (general options)." on page 173.
File "Save"
This softkey saves the file that is being edited.
This option is only available when the "auto save" option is not active. See
"8.4.6 Customizing the editor (general options)." on page 173.
File "Save as"
This softkey saves the file, that is being edited, with a different name. After saving the file,
one keeps editing the new file. Once the program has been saved, the top of the editing
window will show the name of the new program.
When selecting this option, the CNC shows a list with all the programs already saved. To
save a program with another name:
1 Select the destination folder.
2 Write the program name in the bottom window. To replace an existing program, select
it from the list
3 Press [ENTER] to save the program or [ESC] to return to the editor without saving the
program.
File "Include program"
This softkey may be used to import the content of a part-program into the one being edited.
Any program that may be accessed from the CNC may be imported, even the program
currently in execution. The selected program is added to the one being edited after the block
indicated by the cursor.
When selecting this option, the CNC shows a list of the programs that may be imported into
the one being edited. To import a program from the list:
1 Select the desired program from the list or write its name in the bottom window.
2 Press [ENTER] to import the program or [ESC] to cancel the selection and close the
program listing.
File "Print"
This softkey may be used to print the program in the pre-determined printer.
File "Import"
This softkey is used to import DXF, PIM and PIT files into the program being edited.
• The DXF format is standard for exchanging graphic files. Importing this type of files makes
it possible to generate the part-program directly from a drawing. The files must consist
of points, lines and arcs. See
"8.4.10 Import DXF files" on page 177.
• PIM and PIT files are part-programs used by the 8055 CNC. When importing this type
of file, its programming language is adapted to the one used by the CNC.
When selecting this option, the CNC shows a list of the programs that may be imported into
the one being edited. Select the desired program from the list and press [ENTER].
To Next Page
Loading...
