Operating manual.
CNC 8060
CNC 8065
4.
AUTOMATIC MODE
FFC (Fagor Feed Control)
·112·
(REF: 1807)
4.8 FFC (Fagor Feed Control)
During the execution of a canned cycle of the editor, the Fagor Feed Control (FFC) function
makes it possible to replace the feedrate and speed programmed in the cycle with the active
values of the execution, which are acted upon by the feed override and speed override.
During the machining of the cycle, the user can adjust the feedrate and the speed from the
jog panel, using the feed and speed override switches. When the user sees that the feedrate
and speed values are correct, the new values can be saved in the cycle by simply pressing
a softkey. In the following cycle machinings, the CNC will use the new values saved. The
new values are saved in the program at the end of the execution (M30, reset or error).
The FFC option is available for the roughing and finishing operations of the editor machining
cycles; it is not available for the probe cycles or the ISO cycles of the machining. This option
is also available independently during the execution of a cycle.
The FFC option modifies the feedrate and the speed; it does not change the penetration
feedrate "Fz".
Softkey. Description.
Activating the Fagor Feed Control (FFC) function. The softkey is only active during the
execution of the canned cycles of the editor.
Standard operating mode (non-conversational).
Standard operating mode (conversational).
(A)Softkey to activate the Fagor Feed Control (FFC).
To Next Page
Loading...
Need help?
General
