Operating manual.
CNC 8060
CNC 8065
DIAGNOSIS
24.
Report generation
·459·
(REF: 1807)
24.5 Report generation
Automatic reports generated when accessing the diagnosis
mode
Every time when accessing the diagnosis mode, the CNC generates the following reports.
These reports are saved in the folder C:\CNC8070 \Diagnosis\Blackbox.
Generate a report with the system configuration
A report with all the information offered by the diagnosis mode may be obtained from any
section of the diagnosis mode. This produces a document with all the information about the
FAGOR system installed on a machine such as the software version, status of the remote
modules, installed drives and motors, etc.
Generate the warranty registration report.
The CNC can generate a template so the end user can send to Fagor the documentation
with the serial numbers of all the elements in order to obtain the corresponding warranty. This
template, one printed out, contains the fields that the user must fill out and then send it to
Fagor Automation.
SystemInfo.txt Validation code.
SercosInfo.txt Version of drives, motors and feedback.
To print the information, use the "Print" softkey. Pressing this softkey, the CNC
will request the data it must include on the report. The CNC can create a report
with the data shown on the screen or with the whole configuration of the
system.
This information may be printed or saved to a file. When printing to a file, it
is possible to select the name and location of the file.
To print the warranty registration form, use the "Print" softkey. After pressing
this softkey, select "warranty registration report".
The report may be printed or saved to a file. When printing to a file, it is possible
to select the name and location of the file.
To Next Page
Loading...
