Fagor CNC 8065 - OEM Parameters

Operating manual.
CNC 8060
CNC 8065
MACHINE PARAMETERS
21.
Parameter table description
·393·
(REF: 1807)
21.2.4 OEM parameters
The OEM parameters may be read and written directly in the table or through their associated
variables. The "SIZE" parameter indicates the number of parameters in the table. The table,
which is accessed with the general machine parameter "DATA", has the following structure.
A Name of the selected machine parameter table.
B Name of the parameter.
C Value of the parameter.
D Mode for accessing the parameter from its variable.
E The parameter is affected by the change of units.
F Function describing comment.
The values of the table may be modified at any time. The new values are assumed
immediately without having to validate the parameters. This means that the values and
permissions of the table may be modified while executing a program.
The simulation environment has a copy of this table. On CNC power-up, the values of the
parameters of the real table are copied into the simulation table and from there on, they
become different in the writing of the variables of both tables.
In the simulation table, only the parameter values may be modified, not the rest of the
permissions. The values of the simulation table can only be read or modified through their
variable.
A
B C D E
F
G
To obtain further information about the data appearing in the table, refer to the chapter on machine
parameters of the installation manual.
i