Operating manual.
CNC 8060
CNC 8065
15.
GRAPHICS HD (·T· MODEL).
Configuring and activating the sections.
·268·
(REF: 1807)
15.5 Configuring and activating the sections.
Although the definition of the sections is global for all the defined windows, each window may
have different sections active. To view the sections in a window, one must also enable the
"View sections" option in the window properties. See
"Configuring the graphics window
(properties of each window)." on page 267.
Configuring the sections.
Define the sections (default values).
The “default values” button defines three sections, each of these are perpendicular to one
of the axes and cut the part in half.
Define the sections.
The resulting section will be a plane perpendicular to the vector defined in "Normal" and it
goes through the point defined in "Origin". The color of each section may also be defined.
• The "Origin" data defines the origin of the section.
• The "Normal" data defines the components of the vector normal to the plane, that defines
the orientation of the plane.
Activate the sections.
Each section may be activated individually.
To view the sections on the graphic, one must also enable the "View sections" option in the
window properties. See
"15.4 Configuring the graphics window (properties of each
window)." on page 267. If the "View sections" option is not enabled, the graphic does not
show any section even if they are active. If the "view sections" option is enabled, the diagram
shows the active sections.
This softkey defines up to three planes used to divide the diagram. The sections are global
to all the defined parts. If there is a section defined in X100, it will cut all the parts that reach
this coordinate.
A. Activate the sections in the active window.
B. Section configuration for all windows.
To Next Page
Loading...
