Fagor CNC 8065 - Page 196

Operating manual.
CNC 8060
CNC 8065
9.
FMC (FAGOR MACHINING CALCULATOR).
·196·
(REF: 1807)
Exit the FMC calculator.
• Press [ESC] from any calculator page. The FMC does not modify the program
or the cycle.
• Press the “insert" softkey. If the FMC calculator was accessed from the
program editor, the calculator inserts the selected blocks into the program. If
the FMC calculator was accessed from the cycle editor ([RECALL] key), the
calculator completes the feedrate (F), speed (S) and tool number (T) fields
for the current operation (roughing, semi-finishing or finishing). If the FMC
calculator was accessed from the cycle editor, ([CALC], [CTRL][K] or
[CTRL][A] keys), the calculator will not change the cycle data.