Operating manual.
CNC 8060
CNC 8065
GRAPHICS HD (·M· MODEL).
13.
Graphic environment.
·235·
(REF: 1807)
13.1.2 HD graphics in edisimu mode.
The edisimu mode displays a graphical representation of the program being simulated.
Vertical softkey menu.
The vertical softkey menu displays the options depending on the operating mode calling the
graphic environment; in this case, edisimu mode. Refer to the chapter on “edisimu mode"
for more details on the functionality of these softkeys.
Horizontal softkey menu.
• When the focus is on the program area, the softkey menu displays the options used to
manage the program simulation. The softkey menu is the same as the edisimu mode.
Refer to the chapter on “edisimu mode" for more details on the functionality of these
softkeys.
• When the focus is on the graphics area, the softkey menu displays the options to work
with the graphics. The softkey menu is similar to the graphics of the automatic mode.
A. The graphical area displays a graphical representation of the tool paths, the solid or both.
B. Program or simulated subroutine.
C. Axis position regarding the part zero referring to the tool tip.
D. Active functions "M" and "G".
E. Tool number "T" and tool offset "D".
F. Real feedrate (F real), programmed feedrate (F prog) of the axes.
G. Real speed (S real), programmed speed (S prog) of spindle.
The horizontal softkey menu changes depending on the area in which the focus
is located; graphics area or program area. Use the [FOCUS] key to change the
focus area.
To Next Page
Loading...
