Operating manual.
CNC 8060
CNC 8065
18.
TOOL AND MAGAZINE TABLE
Tool and tool magazine table.
·308·
(REF: 1807)
"Rp" - Tool tip radius
Tool tip radius. For the grooving and cut-off tool, this data assumes a value of 0.
"RpW" - Tool tip radius wear
Tool tip radius wear. The CNC adds the wear value to the nominal tool tip radius to calculate
the actual (real) tool tip radius (Rp + RpW).
In the tool table, it is possible to define whether the wear value being entered must be
incremental or absolute. In either case, deleting the wear value or setting it to 0 implies
resetting the amount of wear to 0. See
"Select the type of wear values to enter, incremental
or absolute." on page 309.
Using incremental wear, the value entered by the user will be added (or subtracted if it is
negative) to the absolute value of the wear. After pressing [ENTER] to accept the new value,
the wear field will show the resulting absolute value.
"Lc" - Cutting length
Length of the cutting edge.
"Ae" - Entry angle
This data is only shown on tools that are not for turning. Penetration angle for pocket milling.
"Zn" - Number of teeth.
This information is only available for "Milling", "Drilling", "Surface milling", “Reaming”,
“boring” and “Other” tools. This data is necessary to work using the DMC function, so that
the CNC can limit the feedrate per tooth between the minimum and maximum.
Tool (length) offsets and offset wear.
The offsets are used to define the tool dimensions in each axis. The dimensions of the turning
tools are defined using these offsets; either these offsets or tool length and radius may be
used for the dimensions of the rest of the tools.
On tools that are not just for turning, e.g. endmills and drill bits, the offsets may also be used
to define the tool position when using a tool holder or an intermediate tool. In this case, the
tool dimensions are defined with the radius and the length.
To Next Page
Loading...
