Fagor CNC 8065 - Page 422

Operating manual.
CNC 8060
CNC 8065
22.
SETUP ASSISTANCE
The circularity (roundness) test
·422·
(REF: 1807)
Movement subroutine
The circular interpolation is carried out using a subroutine. See "22.3.5 Define and execute
the movement subroutine"
on page 426.
The following data is taken into consideration when executing the subroutine.
• Plane where the circle is executed.
• Circle center coordinates.
• Circle radius.
• Programmed feedrate.
• Turning direction.
Parameters to be set
To make the adjustment, it is possible to change the CNC machine parameters or the drive
machine parameters involved. See
"22.3.7 Adjustment of the machine parameters
involved" on page 428.
It is possible to interact with up to 11 different machine parameters. Some of these
parameters are always visible, but some may be defined at will. For each parameter, it shows
its value on each axis of the work plane.
To see the whole list of parameters that may be defined, see section
"22.3.9 Machine
parameters that may be modified".