Fagor CNC 8065 - Page 59

Operating manual.
CNC 8060
CNC 8065
GENERAL CONCEPTS
2.
Work modes and software protection at the CNC.
·59·
(REF: 1807)
Protecting or unprotecting the folders.
In the previous window, when selecting the -i- at the top right hand side, the unit shows the
list of folders and files that are unprotected at the time. In administrator mode and the list
of folders being visible, pressing [CTRL]+[ALT]+[SHIFT]+[TAB] it is possible to protect or
unprotect any folder or file of the system that is not key for the proper operation of the CNC.
Administrator mode.
The access to the administrator mode is enabled with the validation code ("Open system"
software option). If you don't have this software option, (i.e. you have a "closed system") you
will not be able to access the administrator mode and, therefore, you will not be able to install
third-party software.
Protection level.
There is not protection level in administrator mode, the whole disk is unprotected.
Protection password.
The access to this mode is protected with the password "administrator mode", defined in the
utilities mode. When starting the unit up in this work mode, it will request the access
password.
Setup mode.
Protection level.
The setup mode has an intermediate protection level where everything that may be changed
while setting the machine up is unprotected; folders ..\MTB, ..\USERS, ..\DIAGNOSIS and
the Windows register.
Protection password.
The access to this mode is protected with the password "machine parameters", defined in
the utilities mode. When starting the unit up in this work mode, it will request the access
password.
This mode must only be used to install non-Fagor software, to install the CNC (also possible
from the setup mode), to update the operative system or change the system configuration.
The CNC application does not start up in this mode.
.
The unit shows the following image on the desk, with red
background, indicating the active work mode and warning that it
is not a protected mode.
ADMINISTRATOR MODE
The setup mode must only be used to update the CNC software and to set up the machine;
it does not allow installing third-party software. This mode may be used to access the
operative system.
.
The unit shows the following image on the desk, with yellow
background, indicating the active work mode and warning that it
is not a protected mode.
SETUP MODE