RX2530 M4 Upgrade and Maintenance Manual 143
Hard disk drive (HDD) / solid state drive (SSD)
7.3.4.1 Preliminary steps
Ê "Locating the defective server" on page 47
Ê "Locating the defective component" on page 48
7.3.4.2 Removing the defective 3.5-inch HDD module
Ê Remove the HDD module, see section "Removing a 3.5-inch HDD module"
on page 141.
Ê If applicable, remove the HDD from the installation frame, see section
"Handling HDDs or SSDs without installation frame" on page 131.
7.3.4.3 Installing the new 3.5-inch HDD module
Ê If applicable, install the HDD in the installation frame, see section "Handling
HDDs or SSDs without installation frame" on page 131.
Ê Install the HDD module, see section "Installing a 3.5-inch HDD module" on
page 139.
7.3.4.4 Concluding steps
Ê If the HDD is configured using a RAID controller with a RAID level higher
than "0", the rebuild will start automatically, see section "Performing a RAID
array rebuild" on page 99.
To Next Page
Loading...
