234 Upgrade and Maintenance Manual RX2530 M4
Expansion cards and backup units
9.5.3.1 Preliminary steps
Ê "Locating the defective server" on page 47
Ê If applicable, "Configuring LAN teaming" on page 105
Ê "Suspending BitLocker functionality" on page 77
Ê "Shutting down the server" on page 49
Ê "Disconnecting the power cord" on page 50
Ê "Getting access to the component" on page 52
Ê "Locating the defective component" on page 48
Ê Remove the corresponding riser module, see section "Handling riser
modules" on page 67.
9.5.3.2 Removing the defective expansion card
Ê Remove the expansion card, see section "Removing the expansion card" on
page 231.
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card, see section "Removing a slot bracket" on
page 205.
9.5.3.3 Installing the new expansion card
Ê If applicable, install the slot bracket, see section "Installing a slot bracket" on
page 204.
Ê Install the expansion card, see section "Installing the expansion card" on
page 222.
9.5.3.4 Concluding steps
Ê Install the corresponding riser module, see section "Handling riser modules"
on page 67.
Ê "Reassembling" on page 57
Ê If applicable, connect external cables to the expansion card.
Ê "Connecting the power cord" on page 63
Ê "Switching on the server" on page 66
To Next Page
Loading...
